INTERWORK DESCRIPTION     155 19-CRA 119 1170/1-V1 Uen A    

Communicating with the NetOp EMS Server

© Copyright Ericsson AB 2009. All rights reserved.

Disclaimer

No part of this document may be reproduced in any form without the written permission of the copyright owner. The contents of this document are subject to revision without notice due to continued progress in methodology, design and manufacturing. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document.

Trademark List

SmartEdge  is a registered trademark of Telefonaktiebolaget L M Ericsson.
NetOp  is a trademark of Telefonaktiebolaget L M Ericsson.

Contents

1Configure NetOp EMS Server Communication


1   Configure NetOp EMS Server Communication

To configure communication with the NetOp EMS server, perform the tasks described in Table 1. Enter all commands in NetOp configuration mode, unless otherwise noted.

Table 1    Configure NetOp EMS Server Communications

#

Task

Root Command

Notes

1.

Enter NetOp configuration mode and enable communication with a NetOp EMS server.

netop

Enter this command in global configuration mode.

2.

Specify operational attributes:

   
 

Enable the SmartEdge router to send advertisement packets to the NetOp EMS server.

advertise

 
 

Specify the version of the SNMP traps that the SmartEdge router sends to the NetOp EMS server.

snmp version

You must configure the Simple Network Management Protocol (SNMP) community before you specify the version of the SNMP traps that the NetOp EMS server receives. See Configuring RMON and SNMP.

 

Configure the type of encryption, if any, that the SmartEdge router allows on the connection to the NetOp EMS server.

connection-mode

 

3.

Optional.

   

The following example enables communication with a network management system and enables the sending of an advertising packet every 10 seconds to the NetOp EMS server. The node group that the SmartEdge router is assigned is NOCuser1 and the listen port is 6581:

[local]Redback#configure

[local]Redback(config)#netop

[local]Redback(config-netop)#advertise 192.168.0.1 interval 10 node-group NOCuser1  port 6581

[local]Redback(config-netop)#snmp version 2c