![]() |
SYSTEM ADMINISTRATOR GUIDE 72/1543-CRA 119 1170/1-V1 Uen A | ![]() |
Copyright
© Copyright Ericsson AB 2009. All rights reserved.
Disclaimer
No part of this document may be reproduced in any form without the written permission of the copyright owner. The contents of this document are subject to revision without notice due to continued progress in methodology, design and manufacturing. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document.
Trademark List
SmartEdge | is a registered trademark of Telefonaktiebolaget L M Ericsson. | |
NetOp | is a trademark of Telefonaktiebolaget L M Ericsson. |
1 | Enabling Licensed Features |
1.1 | Enable Software Licensing |
1.2 | How to Enable Software Licensing |
Certain features and functions that are supported in theSmartEdge router require a paid software license. To make use of one of these features or functions, you must enable it with a password that is provided by Redback when that license fee is paid. Each feature or function requires its own unique password.
To enable software licensing for one or more of these features and functions, perform the tasks described in Table 1.
# |
Task |
Root Command |
Notes |
---|---|---|---|
1. |
Enable software licensing and access software license configuration mode. |
Enter this command in global configuration mode. | |
2. |
Enable the license for a feature and its functions; enter these commands in software license configuration mode: |
||
L2TP features and functions. IPv6 features and functions |
You must specify the L2TP functions to be enabled. All IPv6 functions are enabled. | ||
MPLS features and functions. |
All MPLS functions are enabled. | ||
Subscriber features and functions. PIM features and functions |
You must specify the subscriber functions to be enabled. All PIM functions are enabled. |
The following example enables the features and functions for paid license features and functions; a unique password is required for each feature or function to be enabled:
[local]Redback#configure [local]Redback(config)#software license !Enable L2TP [local]Redback(config-license)#l2tp lns password l2tp-password !Enable MPLS [local]Redback(config-license)#mpls password mpls-password !Enable up to 32,000 active subscribers [local]Redback(config-license)#subscriber active 32000 password sub-active32-password !Enable ATM dynamic profiles, CLIPS dynamic circuits, HTTP redirect, RADIUS refresh [local]Redback(config-license)#subscriber dynamic-service password sub-dynamic-password !Enable hitless switchover for subscriber sessions [local]Redback(config-license)#subscriber high-availability password sub-high-password