Enabling Licensed Features

Contents

1Enabling Licensed Features

2

Example: Enable Software Licensing
Copyright

© Ericsson AB 2009–2010. All rights reserved. No part of this document may be reproduced in any form without the written permission of the copyright owner.

Disclaimer

The contents of this document are subject to revision without notice due to continued progress in methodology, design and manufacturing. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document.

Trademark List
SmartEdge  is a registered trademark of Telefonaktiebolaget LM Ericsson.
NetOp  is a trademark of Telefonaktiebolaget LM Ericsson.

1   Enabling Licensed Features

Certain features and functions that are supported in the SmartEdge router require a paid software license. To make use of one of these features or functions, you must enable it with a password that is provided when that license fee is paid. Each feature or function requires its own unique password.

Note:  
An individual dual-stack subscriber session requires one IPv4 license and one IPv6 license. Those IPv4 and IPv6 licenses are consumed at the time of authentication, whether subscribers are authenticated locally or through RADIUS. The licenses are not returned to the license pool until the entire subscriber session for both stacks (IPv4and IPv6) is down. For example, if the IPv4 session for a dual-stack subscriber goes down while the IPv6 session remains active, the IPv4 license is not returned to the license pool until the IPv6 session goes down, at which time both licenses (IPv4 and IPv6) are returned to the pool.

To enable software licensing for one or more of these features and functions, perform the tasks described in Table 1.

Table 1    Enable Software Licensing

#

Task

Root Command

Notes

1.

Enable software licensing and access software license configuration mode.

software license

Enter this command in global configuration mode.

2.

Enable the license for a feature and its functions; enter these commands in software license configuration mode:

 

L2TP features and functions.

l2tp

You must specify the L2TP functions to be enabled.

 

IPv6 features and functions

 

All IPv6 functions are enabled.

 

MPLS features and functions.

mpls

All MPLS functions are enabled.

 

PIM features and functions


pim

All PIM functions are enabled.

 

IPv4 subscriber features and functions.

subscriber (IPv4 software license configuration)

You must specify the subscriber functions to be enabled.

 

IPv6 subscriber features and functions.

subscriber (IPv6 subscriber license configuration)

The SmartEdge router supports a maximum of 500 or 64,000 IPv6 subscribers.

2   Example: Enable Software Licensing

The following example enables the features and functions for paid license features and functions; a unique password is required for each feature or function to be enabled:

[local]Redback#configure
[local]Redback(config)#software license

!Enable L2TP
[local]Redback(config-license)#l2tp lns password l2tp-password

!Enable MPLS
[local]Redback(config-license)#mpls password mpls-password

!Enable up to 32,000 active subscribers
[local]Redback(config-license)#subscriber active 32000 password 
sub-active32-password

!Enable up to 64,000 active IPv6 subscribers
[local]Redback(config-license)#subscriber active ipv6 64000 password sub-active-ipv6-password

!Enable ATM dynamic profiles, CLIPS dynamic circuits, HTTP redirect, RADIUS refresh
[local]Redback(config-license)#subscriber dynamic-service password  
sub-dynamic-password

!Enable hitless switchover for subscriber sessions
[local]Redback(config-license)#subscriber high-availability password 
sub-high-password